This version of SSH for OpenVM supports IPv6 networking environments.
To work in IPv6 environments, the SSH service must be set to IPv6. To display
the setting for SSH, enter the following TCP/IP management command:
$ SHOW SERVICE SSH /FULL
Service: SSH
State: Enabled
Port: 22 Protocol: TCP Address: 0.0.0.0
Inactivity: 5 User_name: TCPIP$SSH Process: TCPIP$SSH
Limit: 10000 Active: 0 Peak: 1
File: TCPIP$SYSTEM:TCPIP$SSH_RUN.COM
Flags: Listen IPv6
Socket Opts: Rcheck Scheck
Receive: 0 Send: 0
Log Opts: Acpt Actv Dactv Conn Error Exit Logi Logo Mdfy Rjct TimO Addr
File: TCPIP$SSH_DEVICE:[TCPIP$SSH]TCPIP$SSH_RUN.LOG
Security
Reject msg: TCPIP SSH Connection refused
Accept host: 0.0.0.0
Accept netw: 0.0.0.0 |
If the IPv6 flag is not included, enter the following command:
TCPIP> SET SERVICE SSH /FLAG=IPV6 |
For more information about these commands, see the TCP/IP Services for
OpenVMS Management Command Reference guide.
