[an error occurred while processing this directive]

HP OpenVMS Systems

ask the wizard
Content starts here

Virtual terminals, LAT, and TCP/IP (UCX) Telnet?

» close window

The Question is:

 
We are using virtual terminal with LAT so users
can reconnect to a disconnected process. I am
now running UCX ver 4.1 and need to do same.
Saw previous response using
$ UCX SET COMMUNICATION/REMOTE_TERMINAL=VIRTUAL
to cure.  However when issuing a SHOW CONFIG COMM
the remote terminal section says virtual terminals
are disabled. Is there a UCX parameter that needs
to be set or something to enable the virtual
terminals with my TCPIP sessions?
 
Signed, just another PC guy getting intimate with VMS
 
 


The Answer is :

 
  The following sequence of commands should resolve this situation:
 
    $ ucx set comm/remote=virtual
    $ ucx set conf comm/remote=virtual
    $ ucx disable service telnet
    $ ucx enable service telnet
 
  These commands will change the running system state, the state for
  the next reboot, and then restarts telnet on the running system.
 

answer written or last revised on ( 21-DEC-1998 )

» close window