HP OpenVMS Systems

MOP access to remote console?

» close window

The Question is:

 
I had a Decserver 700 replaced by service today.  When I went into NCP and
 define node decsv4 hardware address **-**-**-** to replace the old one (name
 of decsv4) when I tried to connect node decsv4 it said that Console carrier
 protocol not available - al
ready in use
 
What should I do to get around this so I can reconfigure the decserver?
 
 

The Answer is :

 
  You will need to determine which MOP mechanism is configured
  and in  use (DECnet Phase IV, DECnet-Plus, or LANCP), and then
  use the associated appropriate command interface to connect to
  the DECserver via MOP.  (The OpenVMS Wizard guesses that the
  system is not using DECnet Phase IV for MOP operations.)
 
  If this guess is incorrect, please contact the Compaq Customer
  Support Center.
 

  

     

     
answer written or last revised on ( 24-MAR-2000 )
     
» close window