[an error occurred while processing this directive]

HP OpenVMS Systems

ask the wizard
Content starts here

Cluster path selection?

» close window

The Question is:

 
I have a four node VMS cluster with two FDDI cards in each node. There are two
 rings campus wide. How can I tell which ring is being used for cluster traffic?
 
 


The Answer is :

 
  The OpenVMS Cluster software will configure and will make use of all
  available paths -- this might involve just periodic probing of the
  path for continuity, or it might involve extensive cluster traffic
  traversing the path.
 
  You can explicitly select a path to use via various means, and any
  cluster path failure will cause a fail-over to the best available
  remaining path.  (For purposes of recovery, the failed path will
  continue to be periodically probed.)  For one tool that can be used
  to control the cluster path, see SYS$EXAMPLES:LAVC$STOP_BUS.*.

answer written or last revised on ( 30-MAY-2000 )

» close window