To move to BMC from EFI,
press the Esc key followed by the left parenthesis character [(] (Shift/9),
and then press Return. If AC power is connected to the system, this
command activates the BMC command line interface even if the system
power is off.
If prompted, enter the user
or admin password at the login prompt. If no password has been defined,
you are not prompted for the password.
login>
Use BMC commands at the cli> prompt,
as described in your hardware documentation. For help information
about BMC commands, enter h at the cli> prompt.
When you are finished using
BMC, you can log out of BMC in one of two ways:
Log
out of BMC and return to the system console (EFI) by pressing the
Esc key followed by the BMC Q command:
cli> [ESC] Q
Log out of BMC without returning
to the system console (EFI) by using the BMC Q command. This assumes you have a system password set.
When you enter the Q command, the login prompt appears, as shown in the following
example: